-
43浏览
-
0点赞
-
0收藏
-
10分享
-
613下载
-
0评论
-
引用
期刊论文
hot deformation and processing map of a typical al–zn–mg–cu alloy
journal of alloys and compounds 550 (2013) 438–445,-0001,():
the effects of the deformation temperature and strain rate on the high-temperature flow behavior of 7075 aluminum alloy were studied by hot compressive tests. based on the experimental data, the efficiencies of power dissipation and instability parameter were evaluated, and processing maps were constructed by superimposing the instability map over the power dissipation map. microstructural evolution of 7075 aluminum alloy during the hot compression was analyzed to correlate with the processing maps. results show that (1) the flow stresses increase with the increase of strain rate and the decrease of deformation temperature; (2) the high-angle boundaries and coarse precipitations distributing in the grain interior/boundaries, which may result in the deep inter-granular corrosion and large areas of denudation layer, should be avoided in the microstructures of the final products; (3) the optimum hot working domain is the temperature range of 623-723 k and strain rate range of 0.001-0.05 s-1.
-
问答
暂无问题,成为第一个提问者
【免责声明】以下全部内容由[蔺永诚]上传于[2012年12月01日 08时25分31秒],凯发k8国际首页的版权归原创者所有。本文仅代表作者本人观点,与本网站无关。本网站对文中陈述、观点判断保持中立,不对所包含内容的准确性、可靠性或完整性提供任何明示或暗示的保证。请读者仅作参考,并请自行承担全部责任。
本学者其他成果
同领域成果